Gaseous hydrogen. Thermally activated pressure relief devices for compressed hydrogen vehicle fuel containers included-in-kit

Gaseous hydrogen. Thermally activated pressure relief devices for compressed hydrogen vehicle fuel containers included-in-kitWhat is this standard about? This document establishes minimum requirements for pressure relief devices intended for use on hydrogen fuelled vehicle fuel containers that comply with ISO 19881, IEC 62282 4 101, ANSI HGV 2, CSA B51 Part 2, EC79 EU406, SAE J2579, or the UN GTR No. 13. The scope of this document is limited to thermally activated pressure relief devices installed on fuel containers used with fuel cell grade hydrogen according to SAE J2719

Table 1 – Colour coding for extinguishing media

This was done to eliminate the problems that were encountered with attempting to balance the voltage probes which resulted in measurement errors

When provisions of this type C standard are different from those which are stated in type A or B standards

Recommended thermal comfort requirements

The design and development process of the high voltage electrical equipment should be able to identify hazards and the risks arising from them

BS ISO 15076-1 specifies a colour profile format and describes the architecture within which it can operate

Annex B (normative) General rules relating to safety

in order to standardize the support for a tenprint capture

A water footprint assessment addresses the potential environmental impacts related to water associated with a product

6 Requirements and characteristics

walkways and access systems

Rail technical specifiers